Installation Instructions:Once you have received your new Wynne Window, follow these installation instructions. You may print this page or click
here for aprintable version with no graphics
STEP 1: Clean dust and oil from around rough opening.
STEP 2: Remove window from crate and position on a clean, non-abrasive surface. Position clamp ring facing up.
STEP 3: Remove all clamp ring screws (making an index mark on 2 piece clamp rings will help insure correct placement).
STEP 4: Wipe window flange with dry cloth to remove dust, then install bedding compound.
For bedding compound use:
1) Butyl rubber tape 2) Double stick closed cell foam tape 3) 100% silicone rubber sealant
(Do NOT use an adhesive)
STEP 5: Position window in rough opening from outside making sure of correct placement. All sliding windows must have drains toward bottom.
STEP 6: Reinstall clamp ring on inside, taking care to use existing screw holes. Note:
When using silicone bedding, do not fully tighten clamp ring until silicone is dry. Over tightening when wet WILL cause leaks.
STEP 7: Remove excess bedding compound.
STEP 8:
For acrylic or poly carbonate glazing only, remove protective masking immediately after installation. Delay or exposure to sunlight (UV rays) will make masking removal difficult.